Stacking empty totes two high fits about twice as many on a flatbed. Only square, sound totes should form the lower tier. The main problem is wind, not weight: at about 137 lb and nearly four feet tall, an empty tote is light for its size, so a load can shift or lift even when the total weight is small. Cargo securement rules still apply, so check current regulations and your carrier's requirements.
Why stack at all
An empty 275-gallon tote takes up 48 by 40 inches of deck and weighs about 137 lb. A truck runs out of deck space long before it reaches its weight limit, so you are paying mostly for space.
A second tier fits more totes on the same truck, on the same trip. That is why freight on totes is so sensitive to how they are loaded. How to plan transport.
Which totes can go on the bottom
The lower tier carries the upper one. Even with empties, the load runs down the cage's vertical bars, and those need to be straight.
- Square cage. The diagonals across the top frame should agree closely. How to measure.
- Sound welds. No rust blooms, cracks or field welds.
- Undamaged pallet. No split boards, cracked decks or bent feet. Pallet types.
- A suitable stack rating. Do not rely on a tote for stacking if its plate is unreadable or it is not designed for it.
- Matching height. Mixing 46-inch and 53-inch totes in a lower tier leaves an uneven upper deck, and straps can go slack.
The securement problem is wind, not mass
Flatbed securement is usually thought of in terms of heavy freight that wants to keep moving when the truck stops. An empty tote is the opposite: a large flat side with very little weight behind it. A side wind can push hardest on the outer totes of the top tier, which also have the least friction holding them down.
That leads to some specific practices:
- Strap over the cage top rails, not around the bottle. The cage is the structure, and a tight strap can deform a bottle.
- Use enough straps for the size of the load, not just the weight. Think about how many totes each strap really holds down.
- Protect the strap at every rail. A tensioned strap over a steel tube corner can wear through its webbing.
- Seat the upper tier properly. Many cage tops are shaped to accept a pallet above. Use that where the design allows it.
- Recheck tension soon after starting. Empty loads settle, so a strap that was tight at the start may not stay tight.
- Block the front and rear where needed. Light loads have little friction, so they can walk forward under braking.
When not to stack
| Situation | Reason |
|---|---|
| Cages out of square or doubtful | No safe lower tier |
| Strong crosswinds expected | Wind load is the main risk |
| Mixed heights in the lot | Uneven upper deck, straps go slack |
| No forklift at the destination | The upper tier cannot be unloaded safely |
| Overhead clearance unknown | Two tiers on a deck may not clear doors or bridges |
| New or rebottled totes that must stay unmarked | Contact between tiers can scuff bottles |
At the receiving end
A two-tier load needs a forklift with enough reach for the upper tier, and everyone on site should know that upper totes come off first.
- Release straps only when it is safe, and watch for totes that have shifted in transit.
- Take the upper tier off first, working in order from one end.
- Do not climb on the load. Empty cages are not a walkway.
- Have a firm, flat place ready to set totes down. Empty totes can blow around on an open pad.
- Count and inspect the load while the driver is there, and note any damage on the delivery receipt.
Filled totes are a different question
All of this applies to empties. A full 275-gallon tote weighs roughly 2,350 lb with water, and more with a denser product. That brings heavy-load securement into play, along with liquid surge, the tote's stack rating and its maximum gross mass.
Stacking full totes for transport is a specialist decision, so check current regulations and speak to your carrier. Weights and ratings are a good starting point, and unloading access is worth planning at the same time.
Need totes moved? Delivery is available through partner suppliers, and availability depends on your location. Tell us the quantity and destination through the quote form, and a partner supplier can follow up.
Published July 7, 2025.