Ask for seven photographs: the lot as it stands, a typical unit full height from the valve side, the UN plate close enough to read every character, a backlit bottle wall, the lower corner radius, the pallet bearers, and the valve open. Then ask four questions: what did it hold and who says so, what are the inspection and test dates, how has it been stored, and what is the loading situation. A price that looks too good is usually a grade problem, a history problem or a freight surprise.
The problem with remote buying
You cannot press the wall with a thumb to feel sunlight embrittlement. You cannot look inside under good light. You cannot run a tape across the cage diagonals.
What you can do is ask the seller to show the things that photograph well, and judge the seller by how readily they do it. In practice the second signal is often worth more than the first.
The seven photographs, in order
- The lot as it stands. Wide, from a distance. Is it on a paved pad or in mud, single-stacked or two high, covered or in full sun, tidy or abandoned? Storage conditions predict condition.
- A typical unit, full height, from the valve side. Not the best unit, a typical one. Ask for it in those words.
- The UN plate, close enough to read every character. If the seller will not or cannot photograph a plate, that answers several other questions. What the plate tells you.
- A backlit bottle wall. A bright lamp held against one side, photographed from the other. It shows haze, film and ghosting that are otherwise invisible.
- The lower corner radius. Where bottles fail. White, crackled or crazed areas there are stress whitening, which is a serious defect rather than a cosmetic one.
- The pallet, from underneath or at an angle showing the bearers. Timber rot and delaminated decks only show from this angle, and the pallet is the component nobody specifies.
- The valve, open. Confirms it is there, turns, and has a handle. A seized valve means parts and labour before the container can even be tested.
Seven photographs is a reasonable request for any lot of containers, and a careful seller will not mind it.
The four questions
1. What did it hold, and who says so?
The answer should be a product name, and the source should be the site that emptied the containers. Not a trade category, not a broker's assurance. This one answer decides what the container can safely hold next and what cleaning it needs. If the tote will touch food or drinking water, confirm suitability with the supplier and current regulations. Why it has to be traceable.
2. What are the inspection and test dates?
This matters if you intend to ship regulated materials, and then it is the most important question on the list. IBCs used for regulated materials need periodic inspection and testing, with records, and a unit whose interval has lapsed may not be usable for that purpose. Check current regulations for the intervals that apply. Reading the plate.
3. How has it been stored, and for how long?
Several summers in full sun is a different container from the same years under cover, even if both look clean. Two high outdoors on soft ground for a few winters can mean twisted cages. Missing lids mean standing water and possible freeze damage.
4. What is the loading situation?
A forklift and an operator on a paved pad, or hand-moving from behind a building? This is a freight question rather than a condition question, and it can change the delivered cost noticeably. Access problems at the far end.
Red flags in the conversation, not the container
| Phrase | Likely meaning |
|---|---|
| "They had soap in them" | Nobody knows the product name |
| "Food safe" with no records | A material claim, not a history claim |
| "Cleaned" with no details | Rinsed with a hose |
| "I can send one photo" | The rest of the lot is worse |
| Declaration from a broker | No link to the site that emptied them |
| "The plate is there somewhere" | Illegible or missing |
| Price far below others for the grade claimed | Grade, history or freight surprise |
| "Freight is cheap, do not worry about it" | Freight has not been quoted |
The last two are the ones that cost real money. A cheap lot of used containers is often a grade problem you discover on arrival, a history problem you discover at an audit, or a freight number nobody actually priced.
Protect yourself in the terms, not just the inspection
- Agree the grade definitions in writing before money moves. "Good condition" is not a definition, and grade names vary between suppliers. Why definitions need writing down.
- Agree an inspection window. A few business days with photographs is a common arrangement. After that the shipment is usually treated as accepted.
- Agree who pays return freight on a grade dispute, in advance. This clause decides how a disagreement actually ends.
- Get freight as a separate line. If it is bundled into the unit price you cannot tell which number is wrong.
- Ask what would change the price. A quote that states its own conditions is less likely to be revised at collection.
When the lot arrives
Inspect while the driver is still there. Count the units, walk the load, and note anything on the delivery receipt at unloading. Transit damage claimed afterwards is very hard to settle.
Then work through a full inspection on a sample of units before you put anything into service. The used tote checklist.
Looking for used totes? Describe the quantity, grade and what you will store, and we pass your request to a partner supplier, who can follow up with photographs and a quote. Pricing is by quote, and availability depends on your location.
Published March 9, 2026.